Time：2018-06-08 16:32:27 来源：/
Environmental factors have a lot of influence on the ventilation and heat dissipation, the main factors affecting the environment around the air compressor are the following three phenomena: the distance from the air compressor is too close to the wall or other obstacles; and there may be other heat sources near the air compressor. The installation and use of air compressors are carried out according to the requirements of installation and use of air compressors.
The clogging of the radiator is also a problem. Because the dust around the air compressor is likely to be more dust, it will cause long-term operation and cause the surface of the radiator to adhere to a layer of dust or mud, which will affect the effect of heat dissipation. Too dirty oil filters may cause a certain degree of overheating of air compressors. Because the air compressor oil filter is too dirty when it is too dirty, the oil can not enter the air compressor according to the normal flow. Then the air compressor will be rapidly heated up because of the insufficient cooling of the oil, and of course, the cooling oil surface is too low. The air compressor should be maintained and maintained regularly to avoid the above situation.
If the oil marks are low or the oil is poor, there will be some problems. Air compressor should use the manufacturer's factory special air compressor oil, such as the use of other low or inferior oil may make the viscosity and the specific heat can not reach the standard cause the temperature is too high.
The air compressor should be reminded that the air compressor should use the original spare parts and maintenance bags, because it must be tested and tested, and can meet certain technical requirements. It is impossible for counterfeit products and substitutes to achieve. Only using the original spare parts can ensure the stability and reliability of the air compressor operation, and it will be serious once it is interrupted. It threatens the normal operation of the air compressor, and then affects the production progress, production quality and operation efficiency of the users.